I wanted a couple of special knit accents to my wedding ensemble, seeing as I am a bit of a knitting nut!  If I had more time, I am sure Iwould have knit my own wedding dress, but with less than three months for an engagement, I just was not prepared to rush a design and dress out- especially for a beach wedding.  Instead, I’ve made a beaded scarf and now I have finished the garter.  It is a bit different from the traditional garters that I have seen, but I think that it will be treasured. 

I used Aslan Trends Class Yarn, which is a sport weight yarn as the main part of the garter.  For the blue edge, I used a lace weight yarn that I had bought years ago and never found a use for.  Any lace, light sport weight yarn should do.  The ribbon is 1/8 inch wide.  I knit the ribbed section with white elastic held together with the aslan yarn.  Also,I recommend using a stitch marker to keep track of where the row begins.

The gauge is 14 stitches = 4 inches wide, 8 rows = 1 inch for the ribbing with size four circular needle 16 inches long.

Cast on 70 stitches. 

Row 1: Join without twisting stitches, K5,P2, Continue to end.

Row 2: K5, P2 holding yarn and elastic together.

Continue for 6 more rows, end using elastic in row 8.

Row 9: K1, Yarn Over, continue to end (140 stitches)

Row 10: K2, Yarn Over, continue to end (210 stitches)

Row 11: Knit

Row 12: K2together 3 times, K1 Yarn over 6 times, repeat to end.

Row 13: Knit

Row 14: Knit

Row 15: Bind off using blue or other colored lace/light sport weight yarn.

Lace ribbon into the wholes that were created in Row 9.  Tie the ribbon to hold the garter up on the leg.